Click Bond CB200 Acrylic Structural Adhesive
CB200/CB200-40 is a two-part, thixotropic acrylic structural adhesive engineered for installing Click Bond® adhesive-bonded fasteners and for high-strength bonding across prepared or unprepared metals, engineering thermoplastics, and composites. It cures quickly at room temperature and offers excellent environmental and chemical resistance.
Key Benefits
- ✓ Fast, reliable cure: ~5 min working time; reaches handling strength in ~30 min, ~90% in ~2 hrs, full cure in 24 hrs (at ~75 °F/24 °C).
- ✓ Thixotropic, non-sag paste: stays where you apply it—ideal for vertical/overhead surfaces.
- ✓ Strong & versatile: bonds a wide range of metals, engineering plastics, and composites.
- ✓ Broad service window: typical service range cited to approximately −67 °F to 250 °F (−55 °C to 121 °C).
Typical uses
- Installing Click Bond studs, standoffs, mounts, and rivetless nutplates as a lightweight alternative to drilling, riveting, or welding.
- General structural bonding where speed, strength, and clean application are important.
Support Documents
Technical details (typical)
| Chemistry | Two-part acrylic, thixotropic paste |
|---|---|
| Mix ratio | 8:1 (by volume), cartridge-dispensed |
| Working time @ 75 °F (24 °C) | ~5 minutes (small quantities) |
| Handling strength @ 75 °F (24 °C) | ~30 minutes |
| ~90% strength @ 75 °F (24 °C) | ~2 hours |
| Full cure @ 75 °F (24 °C) | 24 hours |
| Storage / shelf life | Store below ~72 °F (22 °C); refrigerated storage recommended. Do not freeze. Up to ~1-year shelf life when refrigerated. |
FAQs
Yes—CB200 is recommended for installing Click Bond adhesive-bonded fasteners on approved substrates.
It’s a two-part acrylic supplied in an 8:1 cartridge for reliable dispensing and cure.